Rolling mill pressing system setup operation and advantages

In today's finishing mill pressing system, the belt pulley of the synchronous mechanism is wrapped in a screw, the tooth belt mechanism of the tooth belt is arranged on the side wall of the fixed housing, the driven belt pulley mechanism of the tooth belt is wound on the fixed shaft, the fixed axis around the driven belt pulley and the axis of the relative rotatable rotating fixed shaft move upward and downward. The detection equipment is arranged in the fixed housing and is used to detect the number of revolutions of the driven pulley, and the new type can be effectively adjusted.

Depending on the practical application of the screw and steps, reduce or eliminate the displacement deviation of the upper roll by the screw, reduce or eliminate the dimensional deviation of the gap between the upper roll and the lower roll, thus preventing the middle or edge quality better, the anti-reflective wedge locking device for the transverse rolling mill is installed in the frame, And the hydraulic cylinder drives the wedge parts to press or roll to adjust the roll forward Angle and clearance, its structure is simple, safe and reliable.

It can not only effectively reduce the number of replacements, but also help improve the life of the hydraulic cylinder, improve the surface adhesion and accuracy of the advance Angle to ensure the rolling quality. Now through the understanding of the problems in the production process of the rolling mill and theoretical calculation, a new type of deceleration system optimization system is proposed to ensure the normal operation of the system. By collecting and understanding the vibration signals of the gearbox mill, today captures the status of the gearbox mill, locates faults in the mill, learns about pulley test defects and gear tooth surface hardness.

In the process of installation of rolling mill equipment, attention should be paid to the installation of the support plate, the installation of the rolling mill base and the installation of the rolling mill frame, these three parts are the foundation of the entire rolling mill installation, which is important, and control the installation accuracy of the three parts, the rolling mill can ensure the service life and operation cycle of the rolling mill, understand the location of the universal joint axis of the main drive of the plate rolling mill. When understanding its structural composition, first understand the service life of transverse shaft and bearing fatigue.